Prosoft-technology 5201-MNET-101S Uživatelský manuál stáhnout pdf (Strana 42)

101S Protocol Configuration IEC-101 Slave ♦ ProLinx Communication Gateway

Protocol Manual IEC 60870-5-101 v3 Slave (Firmware version 3.xx)

Page 42 of 159 ProSoft Technology, Inc.

August 6, 2010

2.3 [M_SP_NA_1]

This section defines the monitored single-point database. This information is

sourced from the database and is transferred to the remote Master unit.

This section takes the following parameters:

 P

OINT #

 DB

ADDRESS

 G

ROUPS (page 50)

 IV

DB BIT

Each point consumes one bit (1 = On, 0 = Off state). The DB

ADDRESS VALUE

corresponds to the bit offset address in the database.

The DB

ADDRESS should be located in a database area that is being constantly

moved from the gateway to the Master.

For additional information on how to set these parameters, see the Reference

chapter of this manual.

2.4 [M_DP_NA_1]

This section defines the monitored dual-point database. This information is

sourced from the database and is transferred to the remote Master unit.

This section takes the following parameters:

 P

OINT #

 DB

ADDRESS

 G

ROUPS (page 50)

 IV

DB BIT

Each point consumes two bits (00 = intermediate, 01 = off, 10 = on and 11 =

intermediate). The DB

ADDRESS value corresponds to the bit offset address in

the database.

The DB

ADDRESS should be located in a database area that is being constantly

moved from the gateway to the Master.

For additional information on how to set these parameters, see the Reference

chapter of this manual.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 158 159

Komentáře k této Příručce

Žádné komentáře

Prosoft-technology 5201-MNET-101S Uživatelský manuál Strana 42

Komentáře k této Příručce

Související produkty a manuály pro Relé Prosoft-technology 5201-MNET-101S