ProSoft Technology ProTalk PTQ-104C Provozní pokyny stáhnout pdf (Strana 15)

Configuring the Processor with Concept PTQ-MCM ♦ Quantum / Unity Platform

Modbus Communication Module

ProSoft Technology, Inc. Page 15 of 139

April 29, 2008

2 Configuring the Processor with Concept

In This Chapter

 Information for Concept Version 2.6 Users............................................ 16

 Create a New Project ............................................................................17

 Add the PTQ Module to the Project.......................................................20

 Set up Data Memory in Project.............................................................. 22

 Download the Project to the Processor ................................................. 25

 Verify Successful Download ..................................................................28

The following steps are designed to ensure that the processor is able to transfer

data successfully with the PTQ module. As part of this procedure, you will use

Concept configuration software from Schneider Electric to create a project, add

the PTQ module to the project, set up data memory for the project, and then

download the project to the processor.

Important Note: Concept software does not report whether the PTQ module is present in the rack,

and therefore is not able to report the health status of the module when the module is online with

the Quantum processor. Please take this into account when monitoring the status of the PTQ

module.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 138 139

Žádné komentáře

ProSoft Technology ProTalk PTQ-104C Provozní pokyny Strana 15