Prosoft-technology MVI56E-LDM Uživatelský manuál stáhnout pdf (Strana 14)

Preparing the MVI56E-LDM Module ControlLogix Platform ♦ "C" Programmable

Developer's Manual Linux Application Development Module

Page 8 of 264 ProSoft Technology, Inc.

March 12, 2014

 Port 1

 Port 2

2.4.1 Setup Jumper - MVI56E

The Setup Jumper acts a write protection for the module's firmware. In "write-

protected" mode, the setup pins are not connected which prevents the module's

firmware from being overwritten.

The module is shipped with the Setup Jumper OFF. If you need to update the

firmware or run a module rescue (recovery), apply the setup shunt over both

pins.

2.4.2 Port 1 and Port 2 Jumpers MVI56E

These jumpers, located at the bottom of the module, configure the port settings

to RS-232, RS-422, or RS-485. By default, the jumpers for both ports are set to

RS-232.

2.5 Setting Up a Connection with the Module

If you have not already done so, please install and configure your ControlLogix

processor and power supply. Refer to the Rockwell Automation product

documentation for installation instructions.

Warning: You must follow all safety instructions when installing this or any other electronic

devices. Failure to follow safety procedures could result in damage to hardware or data, or even

serious injury or death to personnel. Refer to the documentation for each device you plan to

connect to verify that suitable safety procedures are in place before installing or servicing this

device.

After verifying proper jumper placement, insert the module into the ControlLogix

chassis. Use the same technique recommended by Rockwell Automation to

remove and install ControLogix modules.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 263 264

Žádné komentáře

Prosoft-technology MVI56E-LDM Uživatelský manuál Strana 14