Prosoft-technology AN-X2-GENI Uživatelský manuál stáhnout pdf (Strana 12)

Page 6 AN-X2-GENI (AN-X-GENI/B) May 2013

Assignment

Not used

Shield out

Shield in

Serial 2

Serial 1

Ensure that the physical ends of the Genius I/O network are properly terminated. The

AN-X module does not have any internal termination.

WARNING!

Set the baud rate and serial bus address for the AN-X2-GENI module

before connecting it to the Genius network.

Ethernet Cabling

AN-X has a standard RJ-45 connector for connecting to Ethernet.

If you are connecting to the AN-X through a router or switch, use a standard Ethernet

cable.

If you are connecting directly to the AN-X module, use a crossover cable.

Software Installation

There is no required software installation for the AN-X2-GENI. All configuration can be

done using the web interface.

CE Installations

If you are installing the AN-X2 in a location which requires CE, install the following

ferrites or their equivalents on the cables:

Steward 28A3851-0A2 two passes on serial cable 2

Steward 28A2025-0A0 on Ethernet cable

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Žádné komentáře

Prosoft-technology AN-X2-GENI Uživatelský manuál Strana 12