Prosoft-technology CLX-APACS Uživatelský manuál stáhnout pdf (Strana 33)

QTS-CLX-APACS Page 27

Master Mode Operation

WARNING!

Never connect the APACS in master mode to the network while the

ACM is controlling I/O. It transmits even if there is no configuration

and will disrupt communication.

The following is a short summary of the steps typically followed. Refer to the

appropriate manual section for details.

Step Operation See page

1 Install the QTS-CLX-APACS module in the

ControlLogix chassis

2 Power down all APACS racks.

3 Connect the module to the APACS IOBUS 7

4 Run the QTS-CLX-MAS master configuration

program, ClxApacsMasCfg.exe

5 Temporarily load the monitor firmware on the

QTS-CLX-APACS

6 Clear the stored ACM configuration on the

QTS-CLX-APACS

7 Power up the APACS racks and wait for the OK

LEDs on all modules to be green

8 Read the captured configuration data that the ACM

sent to the modules

9 Check that all modules and channels are correct 28

10 Assign ControlLogix addresses to the IOBUS data 30

11 Set the module name 32

12 Save the configuration 33

13 Remove the ACM

14 Change the QTS-CLX-APACS to master mode 37

15 Download the configuration to the module 33

16 Configure the module in RSLogix 5000 8

17 Create aliases for RSLogix 5000 35

18 Import the aliases into RSLogix 5000 36

19 Use the aliases to access the data 38

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 52 53

Žádné komentáře

Prosoft-technology CLX-APACS Uživatelský manuál Strana 33