Prosoft-technology 5204SE-MNET-PDPMV1 Uživatelský manuál stáhnout pdf (Strana 211)

Reference 5204SE-MNET-PDPMV1 ♦ ProLinx Gateway

User Manual Modbus TCP/IP to PROFIBUS DP-V1 Pass-Through Master

ProSoft Technology, Inc. Page 211 of 235

December 22, 2009

New Slave Address

Range 0 to 125

Specifies the new address of the slave.

Slave Ident Number

Ident number for the slave, which address should be altered.

No_Add_Change

This parameter specifies whether it is allowed to change the slave address again

at a later stage. If this is not allowed, then it is only possible to change the

address with this function after initial reset. After the initial reset, the slave takes

the default address 126.

00h Change of address is still possible at a later stage

01h - FFh Change of address is only possible after the initial address (the

default address = 126)

Error Code [1 ... 4]

If 'Return Code' equals 8030h ('Negative indication from lower layer'), status

values according to the DP-specification is available in 'Error Code 1'. Error

Codes 2 to 4 are reserved.

(See Return Codes (page 219) and Error Codes)

Fault Information and Extended Fault Information

"Fault Information" Contents "Extended Fault Information" Contents

0001h Current Slave Address out of range -

0002h New Slave Address out of range -

000Ah Failed to send Global Control

request

For additional fault information, see Return

Codes (page 219)

000Bh Remote Station Failure For additional fault information, see Return

Codes (page 219)

00FFh Module offline (not initialized or no valid database)

Slave Data

With this parameter it is possible to deliver user specific data. The data is stored

in the slave if possible (EEPROM, FLASH, etc.)

1 2 ... 206 207 208 209 210 211 212 213 214 215 216 ... 234 235

Žádné komentáře

Prosoft-technology 5204SE-MNET-PDPMV1 Uživatelský manuál Strana 211